How to use it

Thank's to its special adhesive layer, every time that the surface is worn-out and is under the risk of high bacteria payload in a few seconds you can replace you Strapper and your polyethylene chopping board becomes new again.

Easy to apply or replace! You only need to remove the worn-out layer and insert the new one.

1) Open a small fessure with a knife
between Strapper and the board.
 

2) Lift the used Strapper.
 
 

3) Scratch from inside
to outside till an edge is created.
 

4) Take on the edge carefully
without damaging the adhesive.
 

5) Lift a part of the protection
till the middle.
 

6) Lay the new Strapper
in the correct position.
 

7) Take off all the protection
making pression on the part
already adhesivized.

8) Press on Strapper
from inside to outside.
 

9) The cutting board is now
new and hygienic.
 

It's easy to clean, you only need a simple quick sponge wipe to make disappear every trace and thank's to its water resistant qualities it's not subject to colors and flavours.
For a long duration of the chopping boards and of the Strapper layer we suggest washing it by hand with water and washing-up liquid and not in the washing machine.